Connect With Us

Hard Wired Switch – 240V AC 1 AMP LED Dimmer


The Dimmer Switch module is hard wired to the mains power and uses wireless RF for the control communication.

To comply with Australian / NZ wiring rules a Dimmer Switch module should always be used when controlling circuits that require the control device to be installed in the roof space.

This module is only suitable for locating indoors however, it can control lights which have a suitable rating that are located outdoors or in wet areas.

The Dimmer Switch module is not suitable for speed control of ceiling fans. Conventional dimmers cannot be incorporated into a circuit using an iZone Dimmer Switch module


Model numbers CACDSW
Certification AS/NZS 61058; C Tick N29007;
Power supply Input: 220 – 240VAC 50Hz
Power consumption Maximum 2.05 Watts switched on (no load connected)

Minimum 1.2 Watts switched off

Maximum load 1 Amp
Connection Hard wired
Control frequency 433 MHz
Operating Temperature -20oC to +50oC
Environment Suitable for indoor use only
Requirements An iZone Wi-Fi Bridge (COCB) is required to control an iZone Roller blind module
Dimensions Height: 150mm (Excludes mounting lugs and antenna) / Width 85mm / Depth 36mm (Excludes Antenna)

(Designed to fit through a standard 95mm diameter down light hole)

Weight Weight 220g



iZone Smart Plugs
iZone Smart Home Solutions



Warranty Policy
Warranty Registration Form